lamanated Posted April 27, 2008 Report Share Posted April 27, 2008 had a chit chat with the rep this week, and he mentioned the following,the new starter seals have a teflon strip in the center that you shouldn't touch, you can oil the splined shaft though, you are to use a bullet to install then also. the fcu and governor can move a bit so center them before tightening so as to help tubing installation. you should bent the tubes to make sure they fit to the unit not loaded up and held down with the B nut. also use the correct torque, make sure the clamp is tight on the tube as they stop a harmonic vibration that can happen in tubes. never touch the #8 oil supply line. as you'll not get it back on correctly in the field. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.